Chapter 17

17.13

Maintenance

Barcode reader test

When a barcode read error occurs, execute the barcode reader test to identify the cause of the error.

1 Make sure that the analysis mode of the status area is [AutoLoader]. If the
mode is set to [Manual], press the mode switch.
The mode changes to [AutoLoader] mode.

2 Make sure that the auto loader is closed.
3 Display the maintenance menu.
(➤P.264 "17.2 Displaying the maintenance menu")

4 Click [Barcode Reader Test].
The [Barcode Reader Test] dialog box appears.

5 Open the auto loader.
6 Install the rotor.
7 Close the auto loader.
8 Click [Start].
The reading test starts.
If a previous test result was displayed, it is cleared when the test starts.
Wait until the process finishes. When reading finishes, the result is displayed.

9 Check the reading results as displayed on the [Barcode Reader Test] dialog box.

Reading result

[RotorNo]

Displays the rotor number that was read from the barcode.

[CD]

Displays the check digit of the barcode.

283/312
XF-1600 Instructions for Use