Chapter 10

Registering panel/subset panel and workitems

7 Click [OK].
The screen closes and the entered information is displayed in the [Workitem Registration (Auto Loader)]
dialog box.
Go to step 5.
(➤P.103 "10.4.1 Registering a workitem in the worklist (for auto loader analysis)", step 5)
To cancel the registration, click the [Cancel] button. The confirmation dialog box appears. If you click [OK],
the screen closes and returns to the [Workitem Registration (Auto Loader)] dialog box.

5 Check or edit the registered information.

Info.

• The following information is displayed in the [Info.] area:
C: if the workitem was acquired from the host computer
M: if the workitem was entered manually
• To display the workitem information on the right side of the screen, select the row under [Rotor Pos.
Information].
• Use the up and down buttons to change the tube position.
• To cancel the added workitem, select the row and click the [DELETE] button.

6 If necessary, register additional workitems for the remaining tubes in the
same rotor.
Repeat the procedure from step 4.
(➤P.99 "10.4.1 Registering a workitem in the worklist (for auto loader analysis)", step 4)
Any additional workitems are registered at the next available position after previously registered workitems.

7 Click [OK] once you complete defining all of the tubes for the selected rotor.
The dialog box closes and the workitems are registered.
The newly created workitems are highlighted in blue in the worklist.
If you click the [Cancel] button, the workitems will not be added in the worklist.

103/312
XF-1600 Instructions for Use