Chapter 10

Registering panel/subset panel and workitems

6 Click [OK].
The screen closes and the acquired information is displayed in the [Workitem Registration (Manual)] dialog
box.
Go to step 4.
(➤P.106 "10.4.2 Registering a workitem in the worklist (for manual analysis)", step 4)
To cancel the registration, click the [Cancel] button. The confirmation dialog box appears. If you click [OK],
the screen closes and returns to the [Workitem Registration (Manual)] dialog box.

⏺ If creating the workitem manually
Sub-steps 1 to 6 are the same procedures described in “10.4.1.4 Register a workitem for each primary ID.”
(➤P.101 "10.4.1.4 ⏺ If creating the workitem manually")

1 Click [ADD].
2 Enter the [Primary ID].
3 Enter the [Patient Information] and [Measurement Information].
4 Select the panel from the [Panel Name] drop-down menu.
5 Check the displayed information and enter or correct the [Secondary ID]
as necessary.

6 Make sure that the subset panel name for the primary ID is selected with
in the [Target] column.

7 Click [OK].
The screen closes and the entered information is displayed in the [Workitem Registration (Manual)] dialog
box.
Go to step 4.
(➤P.106 "10.4.2 Registering a workitem in the worklist (for manual analysis)", step 4)
To cancel the registration, click the [Cancel] button. The confirmation dialog box appears. If you click [OK],
the screen closes and returns to the [Workitem Registration (Manual)] dialog box.

105/312
XF-1600 Instructions for Use