Race on 29 y 30 June 2019
2.8.3. The use of homemade cockpit is forbidden, it must be from any recognized slot manufacturer and
manufactured for that particular car model.
2.8.4. It is possible to flatten the lexan slightly to avoid its contact with the chip capacitor and to facilitate the
tilting. If this action is exaggerated or a severe deformation of the lexan is visualized, it will be forced to
return it to its original position or if it were not possible to replace it completely .

2.9. The body optics/windows/etc. must be the original ones of the car in the plastic version.
2.10.

It is allowed to pierce the cockpit and the crystals for the antenna output of the chip. Without excesses.

3. CHASSIS:
3.1. The chassis will be the original supplied by the manufacturer in its different versions, without any
modification, except those described below:
3.1.1. A minimum recess of the chassis in the outer perimeter in contact with the body once assembled, for
the correct tilting of this.
3.1.2. A minimum recess of the chassis in the anchor perimeter of the motor support.
3.1.3. Adjust the body to the chassis by heating the sides of the chassis with a dryer. Without exceeding.
3.1.4. In those chassis that do not have a perforation already made by the manufacturer for the led of the
chip, it can be done to correctly arrange the lane change sensor of the chip.

4
Revision v.2.7 EN (2019/01/14)