REG. TEC. e CSD 2019 2.7 EN.pdf


Vista previa del archivo PDF reg-tec-e-csd-201927en.pdf


Página 1 2 34517

Vista previa de texto


Race on 29 y 30 June 2019
Any Scaleauto GT is allowed. Slot.it Flat Motor with open side down.

Both LMP2 and GT will follow these regulations, for LMP1 DISCA check the specific regulations keeping the
mandatory limitations, (ratio and motor).

2. BODY:
2.1. Any exterior aerodynamic modification on the original bodywork is prohibited. It must match the supported
models.

2.2. Body filing, sanding or recessing of the body is not allowed, except for the elimination of burrs of plastic or
paint to facilitate body tilt, being this minimum and clearly for this purpose and not exceeding 0.3mm.

2.3. It is forbidden to alter any other aerodynamic aspect on the body. The air inlets, heel pockets, flaps,
spoilers, leaks that are supplied in the standard car must be respected.
The wing is mandatory and will be placed in its original place respecting its anchors. It is allowed to reinforce the
fixation of this to the support by means of adhesives, contact adhesive and / or transparent adhesive tape or the same
color as the spoiler, without excesses and without altering its aesthetic appearance from an overhead view, that is,
the tape will be placed by the lower part of the spoiler to fix it to the support. In case of loss of the spoiler it is
mandatory to stop for repair in the following laps, it will be placed in its original place, that is, in its anchorage points
and, it is allowed to use adhesive tapes for its fixation with the exception that in this situation does not prohibit that
said tape be seen from a top view.

The tape used for this type of repairs will be a single fragment and must not exceed 1 cm. of width nor 3cm. long .

2
Revision v.2.7 EN (2019/01/14)

adplus-dvertising