b. Powering up the sensor:

We need to power up again the sensor, for that, we’ve GND y VCC connectors. We
only need to remind and follow the polarity when welding again the cables on it’s place.
So, take a look when desoldering to have everything clear (polarity) when soldering
again.
c. Pit In / Pit Out detection zones connection (S1 and S2 from the multilane
sensor).

The S2 connector of the multilane sensor will be connected to the Pit Lane entrance
dead strip (in our case, the dead strip of the ND original Pit Lane Set).
The S1 connector of the multilane sensor will be connected to the Pit Lane exit dead
strip (in our case, the dead strip of the ND multilane sensor Set).