Chapter 12

Running samples

3 Make sure that the instrument is in the ready state.
If the analysis status LED/instrument status shown in the
bottom left corner of the IPU screen does not light green,
wait until it does.

Analysis status
indicator LED

4 Select the workitem or subset panel of the sample you want to run, and
activate it by clicking

(Active).

This changes the measurement condition setting area and the workarea for the sample.

Caution
Verify that measurement conditions are appropriate for running the sample.
There is a risk of inaccurate results and data analysis that require additional measurement if the conditions
are not set properly.

Note:
The instrument acquires data for the active workitem or subset panel.

173/312
XF-1600 Instructions for Use