Chapter 10

Registering panel/subset panel and workitems

5 Click [Merge].
When merging is successfully completed, the dialog box on the
right appears.

Note:
If you select workitems that cannot be merged, the [Warning] dialog box appears. Click [OK] to close the
[Warning] dialog box. After clicking [Cancel] in the [Merge] dialog box, go back to step 2 to reselect
workitems that can be merged.

6 Click [OK].

7 Confirm that a new workitem merging the selected workitems is added to the
top of the worklist.
The [Status] of the merged workitem displays [Merged].

10.17

Configuring acquisition conditions

You can modify the acquisition conditions of an unmeasured workitem in the measurement condition setting area
before running the sample.
Make sure that the workitem is activated so that the measurement condition setting area being displayed is for the
workitem you want to configure.
(➤P.162 "Chapter 12: 12.2.1 Setting acquisition conditions")

Note:
Modified settings are used for acquisition of the workitem but do not overwrite the panel/subset panel
master unless you click
(Save Subset Panel Master) in the worklist commands.
(➤P.122 "10.19 Updating the subset panel master")

10.18

Configuring compensation and creating plots

If needed, you can configure compensation and create plots for an active workitem before running the sample.
Make sure that the workitem is activated so that the workarea being displayed is for the workitem you want to
configure.
(➤P.175 "Chapter 13 Data analysis tools")

121/312
XF-1600 Instructions for Use