Chapter 10

Registering panel/subset panel and workitems

1 Click the [Worklist] tab in the worklist area.
The worklist appears.

2 Select the workitem which you want to set as the primary workitem for
merging.

3 Click

(Merge) in the worklist commands.

The [Merge] dialog box on the right appears.

[Merge] dialog box

4 From the worklist, select the workitems that you want to merge into the
primary workitem.
If you merge multiple workitems into the primary workitem, select the workitems while holding down the Shift or
Ctrl key.
The selected workitems will be displayed under [Workitems to be merged] in the [Merge] dialog box.

Note:
• The following data of the first selected (primary) workitem is applied to a merged workitem to be newly
created:
- Patient information
- Measurement conditions
- Analysis conditions set in the workarea
• You can merge up to 24 workitems with up to 5,000,000 events for each workitem.
• An error message appears if the available space on the hard disk drive is not enough to accommodate
the merged workitem.

120/312
XF-1600 Instructions for Use