Chapter 15

User settings

15.4.12

Auto-validate

Click [System] in the [IPU Settings] tree of the [IPU Settings] dialog box and click [Auto-validate].

[Auto validate after
measurement.]

Select to automatically validate a workitem after the measurement.

[Workitems without
hardware errors]

Select to enable the auto-validate function only for a workitem without errors
due to abnormal hardware conditions. If any of these errors occur during the
run, the workitem analysis results cannot be automatically validated to ensure
data integrity.

[Workitems without
hardware errors &
measurement errors]

Select to enable the auto-validate function only for a workitem without errors
due to abnormal hardware conditions or errors related to sample or
acquisition conditions. If any of these errors occur during the run, the
workitem analysis results cannot be automatically validated to ensure data
integrity.

Caution
By using this function, measurement results without hardware/measurement errors can be automatically
validated in the XF-1600 IPU.
Make sure that this setting is enabled only if the XF-1600 in your laboratory is connected to a host
computer and the results will be checked and validated by the host system.

Note:
When [Auto-validate] is activated, you can still manually validate workitems with hardware or measurement
errors, but only after you verify that the data is valid. For manually validating the workitems, see the
following:
(➤P.115 "Chapter 10: 10.10 Validating workitems")
In the above case, you can see the error information in the data (saved in FCS format or exported to the
host computer) or in the report. For details on these errors, see the following:
(➤P.297 "Chapter 18: 18.3 Causes of errors and remedial actions")

246/312
XF-1600 Instructions for Use